Using Vehicle Battery Power | Radio Shack PRO-2040 specs

20-414.fm Page 8 Wednesday, August 4, 1999 11:12 AM

Using Vehicle Battery Power

To power your scanner from your ve- hicle’s battery power, you need a DC power cord (such as Radio Shack Cat. No. 270-1533).

Cautions:

•Your vehicle must have a 12-volt DC, negative-ground electrical system.

•The recommended DC power cord supplies 12 volts and deliv- ers at least 500 milliamps. The center tip on the barrel plug is set to positive, and the plug properly fits the scanner’s DC 12V jack. Using a DC power cord (or adapter) that does not meet these specifications could dam- age the scanner or the cord (or adapter). The scanner’s display dims if the DC cord (or adapter) you use does not provide the required 12 volts DC.

8

•Be sure you connect the DC cord to the scanner before you connect it to the vehicle’s ciga- rette-lighter plug. Then discon- nect the cord from the vehicle’s cigarette-lighter plug before you disconnect it from the scanner.

Follow these steps to use vehicle battery power.

1.Insert the barrel plug into the scanner’s DC 12V jack.

2.Plug the other end of the adapter into your vehicle’s ciga- rette-lighter socket.

DC 12V Jack

Note: If the scanner does not oper- ate properly when you use a DC cord (or adapter), unplug the cord (or adapter) from the lighter socket and clean the socket to remove ashes and other debris.

Image 8

Radio Shack PRO-2040 owner manual Using Vehicle Battery Power

Contents

Fm Page 1 Wednesday, August 4, 1999 1112 AM Features Fm Page 3 Wednesday, August 4, 1999 1112 AM FCC Notice Contents Scanning Legally Connecting Power Using Standard AC PowerMemory Backup Preparation Using Vehicle Battery Power Optional Outdoor Antenna Connecting AN AntennaTelescoping Antenna Resetting the SCANNER’S Display Connecting AN EARPHONE/ HEADPHONES/ External Speaker Initializing Scanner Traffic Safety Listening Safely Understanding Your Scanner Look AT the Front Panel Programs a 2-second delay for the selected chan Stores frequencies into and accesses the 10 moniEnters the up or down direction in the search mode Turns the data skip feature on and off Look AT the Display Appears when you manually select a locked channel, or During a search hold when the frequency is storedAppears when you program a channel for a two-second Delay before scanning or when you listen to a channel Monitor Memories Understanding the SCANNER’S MemoryChannel-Storage Banks Turning on the SCANNER/SETTING the Volume and Squelch Operation Finding Birdie Frequencies Manually Storing Frequencies in Channels Searching for and Temporarily Storing Active Frequencies Limit Search Direct Search Search Skip Memory Listening to Monitor Memories Moving a Frequency from a Monitor Memory to a Channel Scanning the Stored Channels Manually Selecting a Channel Turning Channel-Storage Banks On and Off Listening to the Weather Band Designating a Priority Channel Special FeaturesUsing the 2-SECOND Delay PRO-2040 has two scan and three search speeds Type Speed Locking OUT ChannelsChanging Scanning and Search Speeds Detecting Data Signals Guide to the Action Bands General Guide to ScanningGuide to Frequencies Typical Band Usage Primary UsageHF Band 3.00-30.0 MHz VHF Band 30.00-300.0 MHz Band Allocation UHF Band Abbreviations High Frequency HF- 3 MHz-30 MHz Very High Frequency VHF- 30 MHz-300 MHz VHF-Hi Band 148-174 MHz Ultra High Frequency UHF- 300 MHz-3 GHz Low Band 450-470 MHz Frequency Conversion Trunked Systems Band Locally Assigned Troubleshooting Care and Maintenance Specifications DC 400 mA full volume unsquelched MHz and 450 kHzOhms Watts maximum Fm Page 43 Wednesday, August 4, 1999 1112 AM Radio Shack