Radio Shack PRO-93 owner manual Storing Talk Group IDs

Block

Size Code

9 10 11 12 13 14 15 16

7

S0 S4 S0 S4

S0

—

—

—

6.Press ENTER for each entry. If you make a mistake, press CL and enter the correct size code.

Notes:

•The default setting of the bank is for Motorola Type II. However, if you set Type I and you want to return to Type II, enter 15 at Step 5.

•To confirm the input, repeat Steps 1–5 and press ENTER. Each time you press ENTER, you confirm the size code. If you find an error, press CL and begin again at Step 1.

7.Press SCAN to start scanning.

Talk Group IDs

There are 10 talk group ID banks and each ID bank has 5 sub-banks. Each sub-bank has 20 ID locations. You can program up to 100 talk group IDs in each bank, so you can program up to 1,000 talk group IDs in 10 banks. When the scanner stops on a transmission in the Motor- ola, or EDACS mode, it checks to see if the ID has been stored. In the closed mode, the scanner only stops on the transmission and displays its text tag if you have stored and not locked out the ID. In the open mode, the scanner always stops on a transmission, but it displays the ID's text tag if you have stored the ID.

Storing Talk Group IDs

To store a talk group ID, press TRUNK when the scanner stops on a voice channel transmission or when a talk group ID is indicated in the manual mode. The bottom line indicates where the ID was stored as % ýJ8M<ý4V44 and then changes toý% û4444.

58 Trunking Operation