4.Insert the supplied AC adapter’s barrel plug into the DC 12V jack on the back of the base.
5.Route the adapter’s cord through the strain relief slot on the back of the base.
Strain
Relief
Slot
7.Plug the adapter into a standard AC outlet. The message counter counts down from 18 to 00 and the TAD- 1029 beeps.
8.Fully extend the base’s antenna and place it in a vertical position.
6.Insert the tabs on the narrow end of the bracket into the inner pair of slots near the bottom of the base as shown and snap the tabs at the wide end of the bracket into place.
Mounting the Base on a Wall Plate
1.Remove the mounting bracket by holding in both tabs and gently pull- ing out the wide end of the bracket.
8
