Radio Shack TAD-1029 owner manual Deleting Messages, Changing the Remote Operation Security Code

43-789.fm Page 27 Monday, August 16, 1999 8:32 AM

DELETING MESSAGES

To delete the current message during playback, press DELETE on the base or handset.

50.You can use the preset code, or fol- low these steps to change it.

Note: In Step 2 you must begin entering the new code within 20 seconds. Other- wise, the TAD sounds 5 short beeps and 2 long beeps and stops the process. If this happens, simply repeat Step 2.

1.Press REMOTE on the handset. The REMOTE indicator lights.

REMOTE Indicator

Note: You can replay a deleted mes- sage by repeatedly pressing REPEAT on the base or handset before the TAD an- nounces “End of messages.”

To delete all messages in a mailbox or the message center after playback, press DELETE then the mailbox or mes- sage center button. The TAD beeps.

Note: The TAD-1029 does not delete unplayed messages.

CHANGING THE REMOTE OPERATION SECURITY CODE

To use your TAD from a remote tele- phone, you must first enter a 2-digit re- mote operation security code. The security code for your TAD is preset to

2.Press CHANGE () then CODE (7). The TAD announces “Enter new code.” Enter a new two-digit remote operation security code. The TAD announces “New code is xx” and beeps twice.

3.Press REMOTE. The REMOTE indi- cator turns off.

To check the remote operation security code, press REMOTE then CODE. The TAD announces “Code is xx” and beeps twice.

27