Radio Shack TAD-764 owner manual Preparation, Setting the Dialing Mode, Setting the DAY and Time

43-764.fm Page 12 Friday, August 13, 1999 2:43 PM

PREPARATION

SETTING THE DIALING MODE

Set TONE/PULSE on the handset for the type of service you have. If you are not sure which type you have, do this test.

Illus. of TONE/PULSE switch.

Follow these steps to set the current day and time.

Note: If you do not complete each step within 8 seconds, the TAD beeps three times and stops setting the day and time. Start again at Step 1.

1.Use a straightened paper clip to hold down CLOCK (located on the TAD’s right side) until the TAD-764 beeps. The TAD then announces, “Sunday.”

Illus. showing CLOCK switch.

1.Set TONE/PULSE to TONE.

2.Lift the handset and listen for a dial tone.

3.Press any number other than 0.

Notes: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.

If the dial tone stops, you have touch-tone service. Leave TONE/ PULSE set to TONE.

If the dial tone continues, you have pulse service. Set TONE/PULSE to

PULSE.

SETTING THE DAY AND TIME

The answering system records the day and time of each incoming message.

Note: If necessary, adjust VOLUME.

2.To change the day of the week, repeatedly press OGM/REPEAT to move back or PLAY/SKIP to move forward to the current day of the week.

Illus. showing OGM/REPEAT and PLAY/SKIP.

12