R
VOYAGEUR GRAND Wood Insert
9 Appliance Set-up
Remove the zip tie to the lower access cover. It is to prevent the cover opening during shipping.
A. Outside Air Kit Installation
A source of air (oxygen) is necessary in order for combustion to take place. Whatever combustion air is consumed by the fire must be replaced. Air is replaced via air leakage around win- dows and under doors. In homes that have tightly sealed doors and windows, an outside air source is needed. An optional Out- side Air Kit is available.
Items Needed for Installation (not supplied)
•4 inch flex aluminum pipe, or if using alternate material, then it shall be made from durable,
•Phillips head screw driver
•Silicone sealant
Option One - Outside Air Installation Instructions
1.Swing grille down to expose the two screws. Figure 39.1
2.Remove the two screws and pull the access assembly away from the appliance.
3.Assemble the outside air cover plate A supplied in com- ponent pack.
4.
5.Remove the outside air cover plate B on outer can and dis- card. Figure 39.2.
6.Install optional flex adapter to outer can with the same screws. Do not use plastic wire ties that come with the kit as they will melt. NOTE: You may need to install the flex pipe into the firebox first depending on installation. Attach flex to adapater with at least 2 screws.
7.Ensure existing access hole in fireplace is sufficient to feed the 4 inch flex.
8.After sliding can into fireplace, feed flex into cut opening to obtain outside combustion air.
9.Level outer can and install appliance. See page 40.
Option Two - Outside Air Installation Instructions
1.Follow steps 1-5 in Option One above
2.Ensure existing acces hole in fireplace will not be covered by the outer can. Existing outside air intake hole may be under at the rear or side of outer can. Outside air may also enter down existing chimney chase in some situations.
3.Repeat step 9 under Option One with one exception. After installing the appliance in the outer can, seal the fireplace opening and trim package with insulation to prevent air leak- age into the room.
WARNING
Fire Risk.
Asphyxiation Risk.
Do not draw outside combustion air from:
•Wall, floor or ceiling cavity
•Enclosed space such as an attic or garage
•Close proximity to exhaust vents or
chimneys
Fumes or odor may result
WARNING
Asphyxiation Risk.
Outside air inlet must be located to prevent blockage from:
•Leaves, snow, ice or other debris Block may cause combustion air starvation
Smoke spillage may set off alarms or irritate sensitive indi- viduals.
WARNING
Asphyxiation Risk.
Length of outside air supply duct shall NOT exceed the length of the vertical height of the exhaust flue.
•Fire will not burn properly
•Smoke spillage occurs when door is opened due to air starvation.
Grille hinges |
| |
downward |
| |
Remove Screws & |
| |
Pull Access Assembly | Remove Outside Cover | |
away from Insert | ||
Plate A (Discard) | ||
Figure 39.1 | ||
|
Outside Air Cover |
Plate B (Discard) |
Termination |
Cap |
Flex Adapter |
Figure 39.2
September 25, 2012 | Page 39 |
