Radware VOYA-GRAND-MBK D. Blower Replacement, VOYAGEUR GRAND Wood Insert, Pull Access Assembly

VOYAGEUR GRAND Wood Insert

R

D. Blower Replacement

1.The grille on the blower access assembly is hinged. Swing the grille downward to expose the 2 screws.

Figure 22.1.

2.Remove the 2 screws from the blower access assembly and slide assembly away from the appliance.

3.Disconnect the wires from the blower.

4.Remove the 2 screws from the hold down bracket and pull the blower and bracket forward.

5.Remove the blower from the hold down bracket.

6.Remove the protection guards from each end of the blower.

7.Re-install in reverse order. Be certain that the hold down bracket’s screws are completely seated in the grom- ments. Insert the locating tab in the hold down bracket into the placement slot.

CAUTION

Shock Risk.

•Do NOT remove grounding prong from plug.

•Plug directly into properly grounded 3 prong receptacle.

•Route cord away from appliance.

•Do NOT route cord under or in front of appliance.

WARNING

Fire Risk.

Do NOT allow hot coals or embers to overflow ash lip

•May melt protective wire coating on fan power cord causing electrical short, fire or injury

CAUTION! Unplug appliance from power source before replacing any components.

Placement Slot

Blower Access

Assembly

Grille hinges	Hold Down
downward
	Bracket

Remove Screws &
Pull Access Assembly	Remove Screws from Hold
away from Insert
	Down Bracket and Pull
	Forward

Figure 22.1

Page 22 7075-166 September 25, 2012