Radware VOYA-GRAND-PMH E. Door Handle Assembly, F. Baffle & Ceramic Blanket Removal, 51mm. Figure

R

VOYAGEUR GRAND Wood Insert

E. Door Handle Assembly

1.Install washer on door handle shaft.

2.Slide door handle through door.

3.Install additional washer(s) as shown in Figure 23.1.

4.Install key in groove.

5.Align groove in latch cam with key; slide latch cam over shaft

6.Install locknut but do not overtighten, the handle needs to move smoothly.

7.Install handle turning in a counter-clockwise motion to desired location on door handle rod. Figure 23.1.

CAUTION! Do not overtighten lock nut. The door handle needs to move smoothly.

F.Baffle & Ceramic Blanket Removal

1.Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.

2.It is easier to remove both baffle boards and ceramic blanket after the tube channel assembly has been partially disassembled and the right side lowered. Follow steps

1 through 4 on page 25 for removal of the tube channel assembly. It is not necessary to completely remove the tube channel assembly.

3.Once the baffle protection cover has been removed, pull the baffle boards and ceramic blanket forward about 1 inch (25mm) and then overlap the baffles about 1-2 inches (25-

51mm). Figure 23.2.

4.Slide the tube channel assembly to the left as far as it will go and lower the right side. Remove the baffle boards and ceramic blanket together. Figure 23.3.

Latch Cam	Door Cross
	Section

Door Handle Shaft

Locknut

Spacing	Square Key
Washers
	Fiber Handle

Figure 23.1

4.Re-install in reverse order. Be sure the baffle boards and ceramic blanket are in their proper positions. See Figure 11 .1 on page 11.

Ceramic Blanket

Baffle Boards Overlapping

Figure 23.2

Slide Tube Channel to the Left and Lower Right Side

Figure 23.3

September 25, 2012 7075-166 Page 23