Positioning the Cooker
Checking the parts
The diagrams below show the minimum recommended distance from the cooker to nearby surfaces.
The hotplate surround should be level with, or above, any adjacent work surface. Above hotplate level a gap of 75mm should be left between each side of the cooker and any adjacent vertical surface.
For
A minimum space of 650mm is required between the top of the hotplate and a horizontal combustible surface.
3 pan supports |
Grill pan and trivet |
Griddle plate
Levelling tool and Allen
keys
Handyrack | Meat tin |
Any cooker hood should be installed in accordance with the hood manufacturer’s instructions.
4 main oven shelves
Plinth |
For safety reasons curtains must not be fitted immediately behind the cooker.
We recommend a gap of 1110mm between units to allow for moving the cooker. If a flush fit is required, fit the cooker up to the unit at one side then fit the unit the other side.
A clearance of 130mm is required if the cooker is near a corner of the kitchen to allow the oven doors to open.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly in front of the place it is to be installed (unless it will not fit through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off the cooker, LEAVING THE COOKER STANDING ON THE BASE PACKAGING. See the loose unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove the rear half of the polystyrene base pack.
24
