Connect the mains cable to the correct terminals for your electrical supply type (see fig.). Check that the links are correctly fitted and that the terminal screws are tight. Secure the mains cable using the cable clamp.
These appliances are of type X with regard to protection against over heating of the surrounding surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp sensitivity residual current device (RCD), the combined use of your cooker and other domestic appliances may occasionally cause nuisance tripping. In these instances the cooker circuit may need to be protected by fitting 100mA device. This work should be carried out by a qualified electrician.
Oven Light
Press the oven light switch and check that the light is working.
NB. The oven light bulb is not included in the guarantee
Hotplate
Check each burner in turn. Push in tap and turn to the large flame symbol. Press ignition switch on facia panel.
Grill
Open the grill compartment door. Turn on the grill control and check that the grill heats up.
Oven check
The clock must be set to the time of day before the ovens will work.
Press and hold as above.
At the same time, press - or + until the correct time shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn off the power supply for a minute or two and start again.
Turn on the oven and check that the oven fan starts to turn and that the oven starts to heat up. Turn off the oven.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the cooker. Hook the central keyhole over the central screw. Twist and fit each end keyhole over their respective screws. Tighten the fixing screws.
27
