4-7.Exporting a video data to a DVCAM

When you want to export an video data to a DVCAM, follow steps through.

1. Set a DVCAM to video mode.

Video Mode means you can control a video of a DV tape.

If your DVCAM is in camera mode, change mode selection switch from camera mode to video mode slowly as mentioned 4-4.Capturing a video from a DVCAM in camera mode.

2. Click theDV Export button. The File select dialog box will appear.

Select an AVI file you want to export, and click [SAVE] button. The AVI data will be exported to the DVCAM.

When you check “Record on the tape”, “Video image” and “Rec command” will be sent to the DVCAM. This means the AVI file will be really overwritten to your DV tape. So, you should be careful not to overwrite important DV tapes.

When you don’t check “Record on the tape”, only “Video image” will be sent to the DVCAM. This means the AVI file will not be overwritten to your DV tape. You can just see the video image on the screen of the DVCAM.

NOTE

There is time-delay between start of video stream and the DVCAM actually starting

to record. So, for a few seconds at the head of video stream, nothing will be recorded on

your DV tape.

3.Click the

stop button in the Camera Control Bar to stop exporting.

NOTE

1.Only a Microsoft DV AVI 2.0 with DVSD(Digital Simultaneous Voice and Data) can be

exported to a DVCAM.

2.If you can not to export clear video data, refer to the Chapter 8-2. or 8-3.When you can not export smooth and clear video image to a DVCAM.

43