RCA CC543 Using the Adapter/Charger to Power Your Camcorder, To Remove the Adapter/Charger

Caution: Do not attempt to use a+ower converter” to Use your*AC adapter/charger on a power source other than 120 volts, 50/60 Hz, or the adapter/charger and camcorder may be da&aged. If you wish to operate the AC adapter/charger on a

power source other than 120 volts, 5OKO Hz, use only a transformer-type power converter. Do not use %olid-state” or “switching-type” power converters. They will damage your AC adapter/charger. An’optional CPSOl4 shown on page 3 is

designed for use on 100-240 volts, 50/60 Hz.	.b :.
“’

Using the Adapter/Charger to Power Your Camcorder

Plug in AC Outlet

A d a p t e r / C h a r g e r - -

PO

Indicator

DC/	AdapterlChargel
OUTPUT		‘DC IN 9.6V Jack
- _	n\r r-..%.,a

1. Connect one end of the adapter/

charger’s cable to the adapter/

charger’s DC OUTPUT jack and the other end to the DC IN 9.6V jack on the back of the camcorder.

2.Plug the adapter/charger into the nearest AC outlet (12OV, 50/60 Hz).

3.The POWER indicator on the adapter/charger will light when it is properly connected.

Notes: The adapter/charger cannot charge the battery and operate the camcorder at the same time. If you connect both, the adapter/charger will power the camcorder. Remove the adapter/charger’s cable from the DC OUTPUT jack to charge the battery.

When using the adapter/charger to power the camcorder, the battery level indicator may display i-~ . This indicator is used for battery operation and has no meaning when using the adapter/charger to power the camcorder.

To Remove the Adapter/Charger

1.Remove the adapter/charger’s plug from the AC outlet.

2.Remove the adapter/charger’s DC cable from the DC IN 9.6Vjack on the camcorder.

16