Chapter 1: Connections and Setup
Connect the cables to the
If you connected a cable box or satellite receiver to the recorder, you must connect the
The
1a. If you connected a cable box, insert the
1b. If you connected a satellite receiver, insert the
| 2. Connect the other end of the cable (called a wand) in front of the remote sensor that’s on front of the cable |
| box or satellite receiver. Some cable boxes and satellite receivers have the remote sensor labelled, but some |
| don’t. If you see the remote sensor label on your cable box or satellite receiver, go to step 7 (sometimes it’s |
| labeled IR or remote or sensor). If you don’t see a remote sensor label on your cable box or satellite receiver, |
| go to step 3. |
3. Turn off the cable box or satellite receiver.
Satellite | Cable Box |
Receiver |
|
CHANNEL
03
4.Hold the satellite receiver remote control or cable box remote control so that it is touching the front of the satellite receiver or cable box.
5.Slowly move the remote control in front of the satellite receiver or cable box while you press the power button on and off. You must press and release the power button each time you move the remote (holding down the button won’t work).
6.When the satellite receiver (or cable box) turns on, you’ve located the sensor.
7.Place the wand in front of the remote sensor, approximately one inch away from the remote sensor.
Go to page 12
11