Chapter 1: Setup and Connections
Install Batteries in the Remote
1.Remove the battery compartment cover on the back of the remote.
2.Insert new batteries. Match the polarities (+ and
3.Put the battery compartment cover back on the remote.
Important Battery Information
•If you’re not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.
•Dispose of batteries in the proper manner, according to federal, state, and local regulations.
•Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.
•Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
Point the Remote in the Right Direction and Put it in DVD Mode
When you want the remote to operate the Digital Media Recorder, point the remote at the Digital Media Recorder, not the TV. The remote has to be pointed in the correct direction and toward the correct component in order for the remote control’s signal to communicate with the sensor on the component. Make sure there is a clear path between the remote control and the component you want to operate, so the signal isn’t blocked.
Make sure the remote is in DVD mode — press the DVD button.
Turn on the TV and Digital Media Recorder
1.Turn on your TV and tune the TV to the correct Video Input Channel (if you don’t know which channel is your the Video Input channel, go to page 16 for help). If your TV is RCA, GE, or Proscan just press the INPUT button to get to the Video Input Channel.
Note: You can program your remote to operate most brands of remote controllable TVs. Instructions are on page 19.
2. Press the DVD button on the remote control to put it in the correct mode, and turn on the Digital Media Recorder.
| DVD | ON • OFF |
| TV |
| VCR AUDIO AUX | SAT • CABLE | ||
| MUTE |
|
| ANGLE |
|
| CH + |
|
|
| VOL |
|
| VOL |
|
| CH - |
| Up arrow button |
| ZOOM |
| GO BACK | |
| GUIDE |
|
| INFO |
|
| OK |
| Right arrow |
Left arrow |
|
|
| button |
MENU |
| CLEAR | ||
button | 1 | 2 | 3 | OK button |
Down arrow | 4 | 5 | 6 |
|
AGAIN | 8 | ADVANCE | ||
| 7 | 9 |
| |
button |
| 0 |
|
|
REVERSE | PLAY | FORWARD | ||
| RECORD | STOP | PAUSE | |
| OPEN | INPUT ANTENNA | LIVE | |
Use the arrow buttons on the remote to move through
Complete the Interactive Setup
The next few pages step you through the series of screens that will appear the first time you turn on your Digital Media Recorder.
Use the remote control to follow the
Press the OK button to select a highlighted item.
Notes:
You can access the setup screens from the main menu. If you move, get a different program provider for TV shows, or change your connections, you’ll need to complete the Interactive Setup again.
If you don’t see the Language selection screen (below) the first time you turn on the Digital Media Recorder, make sure you’ve tuned your TV to the Video Input Channel that corresponds to the way you’ve connected the TV to the Digital Media Recorder. If you need help, go to page 16.
1) Select on-screen menu language
If you want the
12
