
Chapter 5
SpeedTouch™ Web Interface
Allow multicast from Broadband Network:
Displays whether you to allow/deny multicast messages from the Internet.
Large bandwidth streams, like video streams, have a large impact on your wireless performance.
WMM:
Displays whether WMM is enabled or disabled.
WMM or
Under Security the following fields are available:
Broadcast Network Name:
By default the SpeedTouch™ broadcasts its network name, allowing you to easily recognise your wireless network in the list of available networks. Once you have configured your wireless clients, it is recommended to disable this feature by clearing this check box.
Allow New Devices:
Allows you to change the access control used by the SpeedTouch™.
Encryption:
Allows you to select an encryption level for your wireless network. The following encryption methods are supported by the SpeedTouch™:
The Wired Equivalent Protocol (WEP)
The default WEP key and the default WPA key are printed on the
SpeedTouch™ bottom label.
Before configuring the SpeedTouch™ encryption, make sure you ! know which encryption methods are supported by your wireless
client.
Configure On the Configure page, you can change the configuration details displayed on the
Details page.
WEP The Wired Equivalent Privacy (WEP) algorithm protects wireless communication from eavesdropping.
WEP relies on a secret key that is shared between the wireless client (for example a laptop with a wireless Ethernet card and the SpeedTouch™. The fixed secret key is used to encrypt packets before they are transmitted. Meaning during transmission between client and AP ("in the air") the information in the packets is encrypted.
If your wireless client(s) support(s)
To enable WEP:
1Select Use WEP Encryption
2In the WEP Key Length list, click the desired Data Security level (either
3In the Encryption key box, type a Network key of your choice. In case of:
64 bit, Alphanumeric:
The
64 bit, Hexadecimal:
The
106 | |
|