RCA SpeedTouchTM706 manual Phone command Is used to

Chapter 4

Voice over IP

To use the service:	Proceed as follows:
Conference Call (3 Parties)	To set up a conference call:
	1	Call person A.
	2	Dial R, 2.
		Person A is put on hold.
	3	Wait for the dialling tone.
	4	Dial the number of person B.
		Person B picks up the phone.
	5	Dial R, 3.
	Once the conference call has been established, you
	can:
	1	Dial R, 2 to put the 2 calls on hold.
	2	Dial R, 3 to retrieve the 2 held calls.
CLIR on call basis	It is possible to hide your phone number for one
	particular call. Dial *31* directly followed by the
	phone number of person A.
Forced FXO	To make a phone call over the regular telephone
	line:
	1	Dial *01*.
	2	Wait for the dialling tone, and then dial the
		phone number of person A.

Command overview The table below lists all standard service codes of the telephony services. These might be different on your SpeedTouch™, depending on your provider.

Phone command:	Is used to:
R 0	drop a held call
	reject an incoming call
R 1	terminate an active call and switch to the
	waiting or held call
R 2	put a call on hold
	switch between active and waiting or held call
	put a conference call on hold
R 3	establish a 3-party conference call
R 4	transfer a call
*31*	make an anonymous call (use CLIR) on call
	basis
*01*	use the regular telephone line

Address book On the SpeedTouch™ Web pages, an address book is available list your contacts, so that you can easily call or e-mail them. For more information, see “5.5.2 Address Book” on page 70.

46 E-DOC-CTC-20051017-0148 v1.0