RedMax TR2350S manual Operation

Models: TR2350S

1 72
Download 72 pages 61.87 Kb
Page 14
Image 14
8. Operation

TR2350S

8. Operation

OP1

STARTING ENGINE

Manual backgroundWARNING

The cutting head will start rotating upon the engine starts.

1. Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.

2. Push the primer pump several times until overflown fuel flows out in the clear tube. (OP1)

3.Move the choke lever to the closed position. (OP1)

(1)primer pump

(2)choke lever

(3)close

(4)open

Manual background NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

STOPPING ENGINE (OP2)

1.Release the throttle lever and run the engine for a half minute.

2.Shift the stop switch to the "STOP" position.

Manual backgroundManual background IMPORTANT

Except for an emergency, avoid stopping the engine while pulling the throttle lever.

OP2

 

 

(3)

(2)

 

(1)

(a)

 

4.Set the stop switch to the "RUN" position. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it. (OP2)

(1) stop switch

(2) RUN

(3) STOP

OP4

 

.04 in

 

(1~2mm)

(1)

ADJUSTING THROTTLE CABLE

• The normal play is 1 or 2mm when measured at the carburetor side end. Readjust with the cable adjuster as required. (OP4)

(1) cable adjuster

(b)

OP3

(a)lockout lever

(b)throttle trigger

5.Firmly grasp (a) and (b) with left hand, pull the starter knob quickly until engine fires. (OP3)

OP5

(1)

ADJUSTING IDLING SPEED (OP5)

1. When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.

2. When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter-clockwise.

(1) idle adjusting screw

Manual backgroundManual background IMPORTANT

Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.Move the choke lever downward to open the choke. And restart engine. (OP1)

7.Allow the engine to warm up for several minutes before starting operation.

Manual background NOTE

Warm up the engine before adjusting the idling speed.

US-12

Page 14
Image 14
RedMax TR2350S manual Operation