![](/images/new-backgrounds/1134308/13430813x1.webp)
4. Apply a small amount of the included grease to the | 4 |
|
|
sides of two Wave Washers (88) and two Thrust |
|
| |
|
|
| |
Washers (66). |
|
|
|
Slide a Weld Spacer (89) onto the Left Crank Arm |
|
|
|
(83). Next, identify the Left Track Arm (12), which |
|
| 83 |
is marked with an “L.” Orient the Left Track Arm as |
|
|
|
shown, and slide it onto the Left Crank Arm. Then, | Grease |
| 11 |
slide a Wave Washer (88) on the end of the Left |
|
| |
|
|
| |
Crank Arm. |
|
| 89 |
Slide an M8 Small Washer (18) and an Axle Cap | 66 | 88 |
|
(41) onto an M8 x 19mm Button Screw (56). Next, | 18 41 |
|
|
slide a Thrust Washer (66) onto the shoulder of |
|
| |
56 |
|
| |
the Axle Cap. Then, tighten the Button Screw into |
|
| |
|
| 12 | |
the end of the Left Crank Arm (83). Make sure |
|
| |
|
|
| |
that the Thrust Washer remains on the shoul- |
|
|
|
der of the Axle Cap, and that the Wave Washer |
|
|
|
(88) remains on the end of the Left Crank Arm. |
|
|
|
Repeat this step to attach the Right Track Arm |
|
|
|
(11) to the right side of the elliptical exerciser. |
|
|
|
5. Attach a Pedal (21) to the Left Pedal Leg (14) with | 5 |
|
|
seven M10 x 13mm Button Screws (54), seven |
| 21 | |
|
| ||
M10 Split Washers (85), and seven M10 Washers |
|
| |
|
|
| |
(67). |
|
|
|
Attach the other Pedal (not shown) to the Right | 14 |
| |
|
|
| |
Pedal Leg (not shown) in the same way. |
|
|
|
|
| 67 | 67 |
|
|
| |
|
| 85 | 85 |
|
|
| |
|
|
| 54 |
|
|
| 54 |
6. Apply a thin film of grease to the barrel of an M10 x | 6 |
|
|
65mm Bolt Set (94). Next, fit the bracket on the |
|
| |
|
|
| |
Left Pedal Leg (14) onto the bracket on the Left |
|
| 94 |
Track Arm (12). Attach the Left Pedal Leg to the |
|
| |
|
|
| |
Left Track Arm with the Bolt Set. |
|
| 14 |
|
|
| |
Attach the Right Pedal Leg (not shown) to the |
|
|
|
Right Track Arm (not shown) in the same way. |
|
|
|
| Grease |
| |
|
|
| 94 |
|
|
| 12 |
| 7 |
|
|