INSTALLATION
LOG SET
INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit (set#
a)
b)
c)
d)
e)
f)Embers
g)Vermiculite
h)Rockwool
Note: Install Optional Brick Panels prior to installing logs.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
The "02" refer numbers (i.e. 02-66) are
molded into the rear of each log.
2)Sprinkle the vermiculite around the fi rebox base. Take some of the embers (approx. 1/3 of the bag) and sprinkle over the vermiculite.
NOTE: Keep the gasket on the front edge of the firebox clear of vermiculite.
4)Place the Front Left Log B)
5)Place the Middle Right Log D)
6)Position the Middle Left Log C)
Cutout
fi ts over
edge of the burner
tray.
9)Place the Front Right Log E)
Vermiculite & | Vermiculite | Vermiculite |
Embers | & Embers | & Embers |
3)Place the
Rear Log A)
The front bottom of Log
7)Place the embers on the front lip of the burner as shown below.
8)Place pieces of rockwool on the front lip of the burner as shown below.
FACEPLATE & TRIM
INSTALLATION
1)Lay the faceplate panels fl at, face down on something soft so they don't scratch.
2)Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). See diagram 1. Hint: Don't tighten the trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.
14 | Regency® |