Regency E21-NG2 Installation, Conversion Kit# 534-969from NG to LP, LPG Conversion Kit Contains

INSTALLATION

Conversion Kit# 534-969 from NG to LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER

IF IN DOUBT DO NOT DO THIS CONVERSION !!

Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.

LPG Conversion Kit Contains:

Qty. Part #		Description
1	904-163	Burner Orifi ce #54
1	904-529	5/32" Allen Key

1918-590 Label "Converted to LPG"

1	908-528	Red "LPG" label
1	910-037	LP Injector (Pilot Orifi ce)
1	910-233	Thermodisc Switch
1	918-482	Instruction Sheet
DC Sparker Kit Contains:
Qty. Part #		Description
1	820-475	Bracket DC Sparker
1	820-476	Bracket DC Sparker
1	904-153	Washer #8 External Star
1	904-330	Nut 8-32 Hex

1904-438 Plug Nylon 0.750 Hole, Black

1904-531 Bushing Split Plastic

0.500 in.

6) Remove the Grate by removing the	10) Remove burner orifi ce with 1/2"
screws on each side of the grate.	wrench. Use another wrench to hold
	onto the elbow behind the offi ce
	Replace with the #54 orifi ce in the Kit.

Remove the 2 screws holding	Burner
	Orifi ce
the grate in position.
7) Remove the Burner Tray by removing 1	11) Turn control knob to the “OFF”
screw on each side of the tray, then slide
	position.
the tray to the left and lift out.
	12) Remove the black protection cap by
	hand from the high-low knob (Fig.1).

1904-543 Screw 8-32 x 3/4 Pan Head

2904-553 Screw #8 x 1/2 Type "B",

Black Oxide

1	910-073	Spark Generator Battery
		Holder

1910-074 Spark Generator Switch C/W Wire

1	910-078	Battery Size AA
		Energizer En91
1	910-199	Clip Wire Holder
1	910-903	Wire Fan To Power Cord
		Ground 30 in.
	904-781	Velcro Hook, Black
	904-782	Velcro Hook, Black

Installation of LPG

Conversion Kit:

1)Turn the unit off and allow it to cool to room temperature.

2)Shut off glass supply

3)Unplug or disconnect power source to stove.

4)Remove glass front (see Door Glass Replacement section in the manual).

5)Remove logs and brick panels (if installed).

Remove the 2 screws,

push Burner Tray to the left, and lift off.

8)Pull off the pilot cap to expose the pilot orifi ce.

9)Unscrew the pilot orifi ce with the allen key (provided) and replace with the LP pilot orifi ce in the kit.

Fig. 1

13)Insert a 5/32” or 4mm Allen wrench into the hexagonal key-way of the screw (Fig. 2), rotate it counter-clockwise until it is free and extract it.

Fig.2

Regency® E21-2 Gas Fireplace Insert 17