Regency E21-NG2 Installation, Gas Connection, High Elevation, For altitude, Natural Gas, 0-2000ft

INSTALLATION

GAS CONNECTION

Only persons licensed to work with gas piping may make the necessary gas connections to this appliance.

The gas connection is a 3/8" NPT accessible on the left side of the unit. The gas line connection may be made of rigid pipe, copper pipe or an approved fl ex connector. (If you are using rigid pipe, ensure that the valve can be removed for servicing.) Since some municipalities have additional local codes it is always best to consult with your local authorities and the CAN/CGA B149 installation code.

For USA installations follow local codes and/or the current National Fuel Gas Code, ANSI Z223.1.

When using copper or fl ex connectors use only approved fittings.Always provide a union so that gas lines can be easily disconnected for burner or fan servicing. Flare nuts for copper lines and

flex connectors are usually considered to meet this requirement.

Important: Always check for gas leaks with a soap and water solution or gas leak detector. Do not use open flame for leak testing.

For minimum and maximum supply pressure see the System Data table.

1)If the appliance is to be installed into an existing chimney system, thoroughly clean the masonry fi replace that has been chosen for the Regency® Gas Fireplace.

2)Theapplianceisprovidedwithanopeningon the left hand side of the control compartment for the gas line.

Note: During any pressure testing of the gas supplypipingsystemthatexceedstestpressures of 1/2 psig, this appliance and its individual shut-off valve must be disconnected from the piping system. If test pressures equal to or less than 1/2 psig are used then this appliance must be isolated from the piping system by closing its individual manual shut-off valve during the testing.

CAUTION: If the glass is removed for servicing, it must be replaced prior to operating the appliance. The glass must be fixed in the closed position when operating.

System Data

For altitude:	Natural Gas		0-2000 ft.
	Propane:		0-4500 ft.
Burner Inlet Orifice Sizes:
	Natural Gas		Propane
Burner		#43	#54
Max. Input Rating
- Natural Gas		23,500 Btu/h
- Propane		22,500 Btu/h
Min. Input Rating
- Natural Gas +/-5%		11,750 Btu/h
-Propane +/-5%		11,250 Btu/h
Supply Pressure
Natural Gas		min.	5.0" w.c.
Propane		min.	12.0" w.c.
Manifold Pressure (High)
Natural Gas		3.8"	+/- 0.2" w.c.
Propane		11"	+/- 0.2" w.c.
Circulation Fan: 120 VAC, 60 Hz
Variable Speed: 127 CFM, thermally
activated
NATURAL GAS E21-NG2
For altitude:	2000 ft - 4500 ft.
Burner Inlet Orifice Size:			44 DMS
Max. Input Rating		22,000 Btu/h
Min. Input Rating		+/-5%	11,000 Btu/h

HIGH ELEVATION

This unit is approved in Canada for altitude 0 to 4500 ft. (CAN/CGA 2.17-M91) with the orifi ce supplied.

Regency® E21-2 Gas Fireplace Insert 9