INSTALLATION
29)Locate the ground lug at the receptical box, left of the unit.
30)Connect one end of the supplied green ground wire to the lug with the nut and washer from the kit.
33)Plug the DC spark generator wires to the DC Sparker.
34)Connect the ground wire to the DC Sparker mounting bracket.
Chain
37b) Recommended location to mount the DC Sparker.
Ground
wire from
kit
31)Install the 1/2" bushing to the heat shield.
35)Install the supplied battery into the DC Sparker Box by opening the battery compartment.
NOTE: The battery in the DC Sparker Box will need to be replaced annually.
37c) Note: Remove the bottom louver by unscrewing the four screws located on the hinges.
Battery
Compartment
32) Run the other end of the ground wire | 36) Mount the heat shield to the DC Sparker. |
Secure into place with the velcro, which | |
and DC spark generator wires through | is provided in the kit. |
the bushing on the heat shield. |
|
Heat Shield |
|
37a) Find a location which is not too hot and is easy to reach for changing the battery. Note: It should be kept away from the chain.
38)Tie up the loose wire with the wire clip.
39)Check for gas leaks.
40)Check inlet and outlet pressures.
41)Check operation of fl ame control.
42)Check for proper fl ame appearance and glow on logs.
Installer Notice:
These instructions must be left with the appliance.
Regency® | 19 |
