INSTALLATION
FACEPLATE & TRIM
INSTALLATION
1)Lay the faceplate panels flat, face down on something soft so they don't scratch.
2)Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). See diagram 1.
Hint: Don't tighten the trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.
4)Place the trim on the assembled faceplate panels, aligning the wire connections from the switches with the notch on the left side panel.
5)Connect the fan switch wires by taking the black and red wires with the male ends (in the grey harness) and connect them with the wire connectors from the fan speed control.
Diagram 2
6)Connect the ON/OFF switch wires by taking the black and red wires with the female ends and connecting them to the ON/OFF switch.
7)Tuck the wires into the faceplate to keep them away from the insert using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit. See diagram 3.
8)The power cord should be run behind the faceplate panel.
9)Attach the brass trim to the faceplate by drilling a 1/8" hole through into the faceplate using the hole in the trim as a guide. Fasten the trim to the faceplate panels using the gold plated screws. See diagram 4.
Diagram 4
10)Attach the faceplate panels to the insert body using the 4 remaining black screws. See diagram 5.
11)Push the logo plate into the two holes in the bottom left corner of the faceplate. See diagram 4.
Diagram 1
Hearth Trim Option: Hearth Trim is an option that can be used tofinish off theinstallation when the bottom of the fireplace is higher than the hearth or to raise the fireplace. Lay the faceplate side panels flat, face down on something soft so they don't scratch. Attach the Hearth Trim to the bottom of the faceplate side panels with the screws provided. See Diagram 2. Now attach the assembled pieces to the insert body.
3)Using the connectors provided, join the left side trim (with the ON/OFF switch) to the top trim. See diagram 2. Connect the right side trim to the top trim.
Diagram 5
Diagram 3
18 | Regency® |
