POLE Saw Information
Adjusting Pole Length RPS2N1
The Remington RPS2N1 Pole Saw has a telescop- ing pole assembly that will extend from 57 inches (fully retracted) to 96 inches (fully extended). A cam levered collet is used to hold the pole in posi- tion at any extended length.
1.To extend the pole, loosen the clamping lever (see Figure 18). Pole will slide freely.
2.Pull inner pole section out to desired length of extension. Note: Only extend pole to minimum length required to reach limb that is being cut.
3.To lock pole in position, tighten clamping lever (see Figure 18).
UNLOCKLOCK
Figure 18 - Extending Telescopic Pole
Cutting with the Pole Saw
1.Connect saw to extension cord. Connect exten- sion cord to power supply.
2.Use both hands to grip pole saw. Use only designated grip areas when operating pole saw (see Figure 19). Use frm grip. Thumbs and fngers must wrap around pole saw handle and pole.
3.Make sure your footing is firm. Keep feet apart. Divide your weight evenly on both feet.
4.When ready to make a cut, press in trigger lockout and squeeze trigger (see Figure 20). This will turn pole saw on. Releasing trigger will turn pole saw off. Make sure saw is running at full speed before starting a cut.
5.When starting a cut, place moving chain against wood. Hold pole saw frmly in place to avoid possible bouncing or skating (sideways movement) of saw.
6.Guide pole saw using light pressure. Do not force pole saw. The motor will overload and can burn out. It will do the job better and safer at the rate for which it was intended.
7.Remove pole saw from a cut with saw run- ning at full speed. Stop pole saw by releasing trigger. Make sure chain has stopped before setting pole saw down.
Grip Area
Figure 19 - Designated Grip Areas
Trigger
Lockout
Trigger
Figure 20 - Pole Saw Handle with Trigger Lockout
www.desatech.com | 18 |
