Problem / possible cause | Action |
|
|
LCD: Circuit disconnected!
The air tubing is not connected properly to the humidifier or the device.
1.Check that the air tubing is connected properly to the humidifier or the device.
2.If the alarm is not cleared, stop treatment.
3.
English |
LCD: Low Minute Ventilation!
Minute ventilation level has dropped | Contact your clinician. |
below the alarm setting level. |
|
| |
LCD: Low Respiratory Rate!, High Respiratory Rate! | |
|
|
The respiratory rate level has dropped | Contact your clinician. |
below or has exceeded the alarm setting |
|
level. |
|
|
|
LCD: High Leak! |
|
|
|
High mask leak for more than 20 | • Adjust the mask to minimise leak (see |
seconds. | “Using |
| • Check the air circuit integrity and |
reconnect.
• If the problem persists contact your clinician.
LCD:
•Connection of a
•Mask vents may be blocked.
•ResMed leak port is missing or vent is blocked.
•Ensure the mask has vents.
•Ensure the mask vents are not blocked.
•Ensure the leak port is installed and that the vent is not blocked.
•Ensure oxygen (if in use) has only been connected at the rear of the device.
•If the problem persists contact your clinician.
LCD: Apnoea!
The device detects an apnoea that has | • Breathe normally to disable the alarm. |
exceeded the | • If the problem persists contact your |
| clinician. |
|
|
LCD: Internal Battery Low! |
|
|
|
The internal battery capacity is below | Connect the device to mains power. |
30%. |
|
|
|
LCD: Low SpO2! |
|
SpO2 has dropped below | • Check the attachment of the sensor. |
level. | • If the problem persists contact your |
| clinician. |
|
|
LCD: SpO2 finger sensor failure! |
|
The finger sensor is not connected | Check if the finger sensor is attached |
properly or delivers faulty values. | properly to the finger and connection to |
| the pulse oximeter. |
|
|
LCD: Xpod oximeter disconnected! |
|
|
|
The pulse oximeter is disconnected. | Check if the pulse oximeter is connected |
| properly to the device. |
|
|
Troubleshooting 23
