Weekly, Monthly, Replacing the air filter | ResMed 2011-09 manual

Weekly

1Remove the air tubing from the device and the patient interface.

2Wash the air tubing in warm water using mild detergent.

3Rinse thoroughly, hang and allow to dry.

4Reconnect the air tubing to the air outlet and patient interface.

CAUTION

Do not use bleach, chlorine, alcohol or aromatic-based solutions (including all scented oils), moisturising or antibacterial soaps to clean the air tubing or the device. These solutions may cause hardening and reduce the life of the product.

Monthly

1Wipe the exterior of the device and the pulse oximeter (if used) with a damp cloth and mild detergent.

2Check the air filter to check if it is blocked by dirt or contains holes.

Replacing the air filter

Replace the air filter every six months (or more often if necessary).

WARNING

Do not wash the air filter. The air filter is not washable or reusable

1Remove the air filter cover from the back of the device.

2Remove and discard the old air filter.

3Insert a new air filter.

4Refit the air filter cover.

.

Air filter

Air filter cover

Disinfection

Disinfection of your device helps to prevent the risk of cross contamination.

Disinfect the exterior of the device, and especially the air outlet, with a damp cloth and a disinfection solution (eg, Microzid).

20

Image 25

ResMed 2011-09, 248551/1 manual Weekly, Monthly, Replacing the air filter, Disinfection

Contents

User Guide Stellar Respiratory Care Solutions Making quality of care easy Stellar 100 Stellar Contents Cleaning and maintenance Indications for use IntroductionContraindications Adverse effects Stellar at a glance Patient interface Internal batteryHumidification ResMed USB stick Mobile use Setting up for noninvasive use Attaching the H4i heated humidifier for noninvasive use Setting up for invasive use Hmef Attaching the pulse oximeter Working with other optional accessoriesAdding supplemental oxygen Stopping therapy using oxygen Starting therapy using oxygenUsing the FiO2 monitoring sensor Attaching an antibacterial filter Connecting a sensor About the control panel Stellar basics LCD screen Starting therapyPerforming a functional test Stopping therapy Starting therapyCheck the FiO2 monitoring sensor if in use Check pulse oximeter if in use Working with alarms Turning off the power Using mask-fit Tailoring treatment setup options Using the menus Enu Options Enu Alarm Settings Alarm Volume Parameter Description Setup menu Configuration MenuOptions On, Auto Event Summary Info menuUsed Hours Device Information Data management Cleaning and maintenanceDaily Monthly WeeklyReplacing the air filter Disinfection Alarm troubleshooting TroubleshootingMultipatient use Servicing LCD High Temperature 10, 11, 12 Problem / possible cause Action LCD Internal Battery EmptyLCD System Failure LCD Over Pressure LCD Internal Battery Low Problem / possible cause Action LCD Circuit disconnectedLCD Low Minute Ventilation LCD Low Respiratory Rate!, High Respiratory Rate Other troubleshooting Device does not start when you breathe into the mask Problem / possible cause SolutionDevice does not stop when you remove your mask Treatment pressure seems high Technical specifications Dimensions L x W x H Alarm Volume RangeWeight Air outlet Power supply Classifications IECAir travel requirements Vrms General warnings and cautions Symbols General warnings and cautions Product Warranty period Limited warranty Apac