Copier Functions

C Press [Edit Image].D Press [Image Repeat].E Make sure that [Whole Area] is se- lected, then press [OK].

F Press [OK] twice.

G Place the original, and then press the {Start} key.

Specified Area Repeat

You can use this function only when you are making a copy from the Exposure Glass.

Note

The base point X1, Y1, and the length set by point X2, Y2 deter- mines the area of an image repeat- edly copied.

Limitation

You cannot use the specified area repeat from ADF.

C Press [Edit / Colour Creation].D Press [Edit Image].E Press [Image Repeat].F Press [Specified Area].G Enter the length of [X1] with the 2 number keys, then press [#].H Enter the length of [Y1] with the number keys, then press [#].I Enter the length of [X2] with the number keys, then press [#].J Enter the length of the [Y2] by number keys, then press [#].K Press [OK] three times.L Place the original on the exposure glass, and then press the {Start} key.

Double Copies

One original image is copied twice onto one sheet, as shown.

GCRE032E

1.Set on the exposure glass

A Specify the location of the area's base point (X1, Y1), and its length and width (X2, Y2).

Note

You can set any value in the range of X1: 0~412mm (0”~16.2”), X2: 20~432mm (0.8”~17.0”), Y1: 0~277mm (0”~10.8”), and Y2: 20~297mm (0.8”~11.6”).

B Select the size of the copy paper and the reproduction ratio.

Note

You cannot use the bypass tray with this function.

See the following table for original and copy paper sizes and orienta- tions when using a 100% ratio:

63