Ricoh FV-G030B1 manual 【Example Code】Reading the data from the command 00H

【Example Code】Reading the data from the command 00H

￿Command to send: 02H, 00H, 00H, 01H, 00H, 03H

SOF	Device Code	Read/Write	Page Selection	Command Code	Data Length	Data	EOF
(8bit)	(6bit)	(1bit)	(1bit)	(8bit)	(8bit)	(1byte)	(8bit)
02H		00H		00H	01H	00H	03H

￿Command to receive upon a successful communication: 02H, 01H, 00H, 03H (assuming the data is 00H)

SOF	Data Length	Data	EOF
(8bit)	(8bit)	(n bytes)	(8bit)
02H	01H	00H	03H

【Sequence for the saving commands to the EEPROM】

Please use the following sequence for saving the commands to the EEPROM.

1)Set “1” to the 80H.0 to enable writing to the EEPROM.

2)Send the save data with the page selection “1”.

3)The camera sends back one of the following receiving codes after writing the EEPROM. 01H: OK

17H: EEPROM write error

4)80.0H is cleared to “0” automatically after writing the EEPROM.

Note1: The data cannot be saved to the EEPROM when 80H.0 is “0”.

Note2: When saving the consecutive sequence of commands, the above steps, 1) to 4), are necessary only once.

i.e.) saving the commands “10H, 11H, 12H, 13H”, or “22H, 23H, 24H”, etc.

Note3: When saving the non-consecutive sequence of commands, the above steps, 1) to 4), are necessary for the same number of times.

i.e.) saving the commands “10H, 13H, 19H, 1BH” or “20H, 23H, 25H”, etc.

FV-G030B1	20/38
User’s Guide Rev. 1.02