Ricoh FV-G030B1 manual 1.2DC Iris Lens Connector, 1.3Power-I/OConnector, User’s Guide Rev, 4/38

1.2DC Iris Lens Connector

￿M1951 (EMUDEN) or equivalent.

Pin Assignment

Pin No.	Signal Name
1	DAMP-
2	DAMP+
3	DRIVE+
4	DRIVE-

1.3Power-I/O Connector

34

1 2

￿HR10A-7R-6PB（Hirose）or equivalent

￿This connector is for the power supply (12Vdc) and input /output signals.

￿Use HR10A-7P-6S (Hirose) or equivalent for the cable side.

Pin Assignment

Pin No.	Signal Name	IN / OUT	Voltage
1	GND	IN	0V
2	I/O-1	OUT	+3.3V LVTTL
3	I/O-2	OUT	+3.3V LVTTL
4	TRG_In-	IN	Low: Smaller than +1.0V (Opt. Isolated -)
			High: +3.0 to +26.4V (Opt. Isolated +)
			*potential difference between TRG_In- and
5	TRG_In+	IN
			TRG_In+
￿
￿ 6	POWER IN	IN	+10.8 to +26.4 Vdc

￿Output signals can be assigned through the camera setting communication. (Device Code = 00H, Command = F0H and F1H)

IO Signal Patterns for Pin No.2 (I/O-1) and Pin No.3 (I/O-2)

	Command No.			HR10A-7R-6PB (Hirose)
F0H[3..0]	F1[3]	F0H[7..4]	F1[4]	I/O-1 (Pin No.2) / I/O-2 (Pin No.3)
For I/O-1 (Pin No. 2)		For I/O-2 (Pin No.3)
0H	-	0H	-	FrameTriggerWait
(initial setting)				(initial setting for I/O-1)
1H	Set Value	1H	Set Value	UserOutput
2H	-	2H		ExposureActive
		(initial setting)		(initial setting for I/O-2)
3H	-	3H	-	TriggerAuxiliary
4H	-	4H		TriggerInternal
5H	-	5H		SensorReadOut
6H	-	6H		StrobeSignal
7H-FH	-	7H-FH	-	For Test Use Only

FV-G030B1	4/38
User’s Guide Rev. 1.02