Copying

Copying from the Bypass Tray

2

Use the bypass tray to copy onto OHP transparencies, adhesive labels, translucent paper, postcards and copy paper that cannot be loaded in the paper trays.

❒ The machine can automatically detect the following sizes as standard size copy paper:

Metric

A3L, A4KL, A5KL,

version

81/2" ⋅ 13"L

Preparation

When the duplex unit is attached, the default is [1 Sided→2 Sided].

When copying from the bypass tray, select [1 Sided] for copying in [Dup./Combine/Series] (for example [1 Sided→1 Sided] or [2 Sided→1 Sided ] ). You can change the initial set- tings. See p.94 “Duplex Mode Priority” .

Important

❒When paper larger than 433 mm in size is used, the paper may become wrinkled, may not be fed into the machine, or may cause paper jams.

Note

❒If you do not use the standard size copy paper or if you use special pa- per, you should input vertical and horizontal dimensions. See p.16 “Placing custom size originals”. The sizes that you can input are as follows:

Metric

•

Vertical: 100–297 mm

version

• Horizontal: 148–600 mm *1

Inch

•

Vertical: 3.9"–11.6"

version

•

Horizontal: 5.8"–23.4” *1

*1 The range is 148–432 mm (5.8"–17") when the booklet finisher is in- stalled.

Inch

L

, 11"

⋅

17"

L

1

⋅

KL

version

A3

 

 

, 8 /2"

 

11" ,

51/2" ⋅81/2"L

 

 

 

❒ When copying on OHP transparencies or paper heavier than 128 g/m2 (about 34 lb.), you need to specify the paper type. See p.22 “When copying onto special pa- per” .

❒ The maximum number of sheets you can load at the same time depends on paper type. The maximum number of sheets should not exceed the upper limit.

A Open the bypass tray.

ZDSH110J

20