Ricoh Note, Note, Note, Note, Note, Note, [OK], Start, [Off], [User 1], [User 2], ❖Auto Class, ❖Paper Type, ❖Deflector Angle, [On (Below half)]

Settings You Can Change with User Tools

❖No.of ldling Rotations: Quality Start

When you use the Quality Start mode, you can select how many times the drum unit idles.

Note

❒Default: 7 times

❖Deflector Angle

You can change the angle of the wing guide depending on the pa- per type you use.

• Up (Select this setting when standard thickness or thin pa- per misfeeds at the paper exit section occur frequently.)

• Down (Select this setting when A4 – B5 JIS, 81/2" ⋅ 11" thick pa- per is not delivered properly to the paper delivery tray.)

Note

❒Default: Auto

❖Auto Class

Instead of using the Separate mode, you can make the following settings:

• Start Automatically (After the last page of each printing set is fed out to the paper delivery tray, the machine stops for a few seconds. Then, the next cycle begins.)

• Stop (After the last page of each printing set is fed out to the pa-

per delivery tray, the machine stops. If you press the {Start} key, the next cycle begins.)

Note

❒Default: Stop

❖Master/Ink Remaining Volume

Specifies whether you can check the amount of ink and master.

•[Off] (You cannot check the re- maining amount of ink or mas- ter.)

•[On (Below half)] (When the re- maining amount of ink or mas- ter is less than half, the display panel indicates these amounts when you turn on the main switch.)

Note

❒ Default: Off

❖Paper Type

You can select the paper type. 5

Note

❒Default: Standard

❖Paper Type: User1–2

You can register a frequently used paper type and have it shown on the paper type menu as [User 1] or

[User 2].

Note

❒Default: Standard: No Feed

ASelect the paper type.

•Standard: “No feed” “Dou- ble feed”

•Thick Paper: “No feed” “Dou- ble feed” “Medium”

BPress [OK].

157