Ricoh VT1730 manual Place the paper on the paper feed table

OPERATION Preparation For Printing

4.Place the paper on the paper feed table.

~Make sure every sheet in the stack is set evenly. This helps prevent paper skewing.

CJ Make sure the leading edge of the staok is in full contact with the front board.

0500 sheets of paper can be loaded at a time. If you load more than 500 sheets, paper may not be fed properly.

~Do not stack paper over the paper feed side plates.

5.Lift the feed roller pressure lever.

Caution: Be careful not to catch your finger between the /ever and the side paneL

6.Make sure that the paper feed side plates contact the paper gently.

O The paper feed side plates should be parallel to the sides of the paper stack, othenvise the paper might not be fed correctly.

Printing on thick and small paper

		r				I
Set the side pads before adjusting the
paper feed side plates to match the
paper	size.			LI -
		l-m-	11
Thick	and small paper:		J	,L3	II	II I
Heavier than 150		g/mz, 39.9 lb
Smaller than 210		x 150 mm,
	8.3” X 5.9”

16

.. ..