Alignment (continued)
NOTE: Always review the section "Check- ing Blade Parallel to the Miter Gauge Groove" before proceeding with this sec- tion.
7.Loosen 1/2 turn the four alignment screws in the top of table next to the sawblade. This will allow the mecha- nism below the table to be shifted sideways.
CAUTION: Blade tips are sharp, to move, grasp blade as shown to avoid injury.
8.Push on side of blade and move it to either the right or left as needed to make the square touch the same amount front and rear. Tighten one screw.
9.Check with square to determine if marked tooth touches square by the same amount at front and rear.
If it does, alternately tighten the other three screws.
If it does not, loosen screw and move blade the required amount.
10.Recheck blade clearance to table insert to make sure blade does not hit at either 90 or 45 degree blade tilt.
Alignment
Screws
22
