Rinnai manual Model 2424WC, Remote Controls- General

INSTALLER’S INSTALLATION INSTRUCTIONS

Remote Controls- General

The remote control for the Continuum 2424WC allows the customer to control the functions of the water heater and to diagnose certain fault conditions.

The Main Controller model MCC-45-3US is intended to be installed in the kitchen or laundry area where the majority of the hot water is being used.

NOTE: The MC-45-3US has a temperature setpoint range of 140-180°F. Other setpoint temperatures must be set through dip switch settings, Contact Rinnai at 800-621-9419 for dip switch settings.

Before installing the remote control, determine the most convenient location. When deciding on the best location for the remote controls, please consider the following items:

1)Place the controllers out of the reach of small children or unauthorised users.

2)Avoid locations where the controller will become hot. (over a stove, near an oven or a radiant heater.

3)Avoid direct sunlight. (The digital monitor can be difficult to read in direct sunlight)

4)Avoid areas where the remote can be splashed with cooking water, oil or sauce.

5)The remote control cables carry low voltage, 12VDC digital.

NOTE: Only one controller can be connected to one Continuum 2424WC water heater. (i.e. Installations with two controllers will not function properly.)

www.rinnaiamerica.com 3 4 Model 2424WC