Connecting the Appliance
1. Attach the air inlet hose to the flue manifold on | a |
| |
either inlet position “a” or “b”. |
|
The plastic tie should be tight over the sleeve. |
|
The unused inlet is plugged with the rubber cap | b |
supplied on the manifold. |
|
2.Connect the flue elbow to the manifold while moving the appliance into position.
Flue Manifold
3.Fit the pipe stopper over the connection between the flue elbow and the manifold. Engage the hook and rotate it until it snaps against the body of the clamp.
Pipe stopper
|
| Hook | ||
Elbow | Manifold | |||
| Pipe stopper | |||
4. Slide the insulation sleeve up to the flue manifold | Fit Clip | |||
|
|
|
| |
and slip the securing clip over the sleeve as |
|
|
|
|
shown. |
|
| Slide |
|
Sock
5.Install the bracket on the rear of the top spacer by tightening 2 screws.
Spacer bracket
Top Spacer
6.Install the wall bracket with two screws. Attach the heater to the wall bracket with 2 screws.
Top Spacer
Wall bracket
Top Spacer
Spacer
Bracket
Wall
Bracket
Rinnai Corporation EX17C / EX22C Manual | 27 |
