Roberts Gorden CGTH-40 Hang the Heater, Suspension Details, Most common for, Heater Assembly

SECTION 4: INSTALLATION

4.7 Hang the Heater

Residential garages come in a variety of sizes, shapes, styles and methods of construction. Because of all these variables, it is not possible to include mounting hardware with the CGTH-Series heater. Although wooden rafters and joists are the most common overhead structural members in resi- dential garage applications, other structural configu- rations are also illustrated below.

In the typical suspension methods shown in Figure 7, lengths of chain are shown as a means of lowering the heater.

Whichever method of suspension is selected, the three required suspension points must be capable of supporting a minimum of 75 lbs. (33 kg) each.

WARNING

Suspension Hazard

Hang heater with materials with a minimum working load of 75 lbs (33 kg).

Failure of the supports can result in death, injury or property damage.

4.8Remove Shipping Screw from Control Housing Door

The blower inside the burner box has a shipping screw installed to protect the blower from damage in shipping. Before hanging or operating heater, remove the shipping screw and paper label from the control housing door, see Figure 6. A nylon washer inside the control housing will fall loose. It is not mandatory to remove the washer from the control housing.

FIGURE 7: Suspension Details

	Most common for
residential applications
Wood Beam
		Wood Screw
		Thread Wire
			Eye Bolt
	Most common for
non-residential applications
Wood Beam		I-Beam	Concrete Beam
Screw Hook		Beam Clamp
min. 3/8" (10mm)
			Anchor
Washer			Snap
			Hook
Locknut
	As required
			Snap
			Hook

4.9 Heater Assembly

•Slide rear movable hanger onto reflector as shown in Figure 8.

•Attach reflector end cap with U-Clips as shown in Figure 8.

							FIGURE 8: Heater Assembly
FIGURE 6: Shipping Screw
							Rear Movable
								Hanger
R		ATT	ENTION
	emove
heater shipping screw						before
		instrallation
removing					or use.		After
screw screw,				discard
		and this				the
			label.
					R
					emove screw
					before use.
RetirezATTENTION
					Retirez
					avant		la vis
l’installation oud’expédition						l'utilisation.
		vis
chauffage.						avant
vis,		Aprèsl’utilisation du
		jetez la et		avoir retiré
			jetez cette				la
					étiquette.
Shipping Screw
and Label
							4 U-Clips	Reflector
								End Cap
								17