CGTH INSTALLATION, OPERATION AND SERVICE MANUAL
4.Install the vent adapter (P/N 90506012) and secure with #8 x 3/8” sheet metal screws as shown
in Figure 26.
5.If the concentric vent has to be cut (see note on Page 28), follow instructions
A.Install the horizontal vent terminal (P/N 90506011) ensure that the air holes intake hole are facing down. Install the flashing plates with the hardware supplied.
(See Figure 27.)
FIGURE 26: Flue Collar and Adapter
(3X) Screw |
P/N 94118106 |
Adapter |
P/N 90506012 |
B. Measure from the end of the adapter to the end of the vent terminal, dimension C, Page 27, Figure 25. Note the dimension here,
__________.
C. Separate the 3” (80 mm) and the 5” (125
mm)vent by pulling the 3” (80 mm) vent out from the end with the internal silicone gas- ket. Remove the internal spring from the
D.Add 3.5” (90 mm) to the dimension noted in step B, this is to allow for the internal joint of the vent. Cut both the 3” (80 mm) and 5” (125 mm) vent to this length and
E.
mm)vent with the internal spacer at the sili- cone gasket end only.
FIGURE 27: Horizontal Venting Configurations
| HORIZONTAL | |
| 90506003 | 90506011 |
| 90506004 |
|
| 90506005 | 90506013 |
|
| |
90506012 |
| |
Heater | A |
|
|
|
Table 1: Components
Part Number | Description | |
90506003 | Concentric Flue | 10” (254 mm) |
90506004 | Concentric Flue | 20” (500 mm) |
90506005 | Concentric Flue | 39” (1000 mm) |
90506011 | Storm Collar | 27.5” (690 mm) |
90506012 | Burner/Vent Adapter | |
90506013 | Wall Plate |
|
F. Push vent terminal away from heater. Insert the cut vent in between the adapter and the vent terminal. Starting at the adapter end, push the plain end of the vent into the sili- cone gaskets. The connection will fit firmly together. If undue force is required to assem- ble the parts, first check the cut length for burrs, second apply warm soapy water to the silicone gaskets.
Note: The gasket construction of this venting is designed to make a permanent airtight con- nection, additional silicone sealant and securing screws are not to be used.
28