Roberts Gorden CGTH-30, CGTH-50 Burner Cycles On And Off Too Quickly, Possible Cause, Try this

SECTION 9: TROUBLESHOOTING

BURNER DOES NOT STAY LIT
Possible Cause	Try this....
Damaged wires between DSI	Replace wires as required.
module and sensing electrode.
Faulty DSI module.	Replace DSI module.
Cracked ceramic at the	Replace electrode.
sensing electrode.
Recirculation of	Check that the 3” (80 mm) inner vent pipe is completely sealed.
exhaust gases.
BURNER CYCLES ON AND OFF TOO QUICKLY
Possible Cause	Try this....
Anticipator setting on	Adjust the anticipator setting to 0.6. See Page 20, Figure 12.
the thermostat is too low

.18
.2	.9
	.7
	.5
.25	.4
	.3

39