SECTION 11: OPERATION AND MAINTENANCE
Gas Line | Check for gas leaks. See Page 40, Section 9. | |
Burner Observation | Make sure it is clean and free of cracks or holes. | |
Window | Clean and replace as required. | |
| ||
|
| |
Blower Scroll, Wheel and | Compressed air or a vacuum cleaner may be used to clean dust and dirt. | |
Motor | ||
| ||
|
| |
Burner Cup and Orifice | Clear of obstructions (even spider webs will cause problems). | |
| Carefully remove any dust and debris from the burner. | |
|
| |
| Replace if cracked or broken. | |
|
| |
Thermostat | There should be no exposed wire or damage to the thermostat. | |
| See Page 42, Section 10. | |
|
| |
Suspension Points | Make sure the heater is hanging securely. Look for signs of wear on the chain | |
| or ceiling. See Page 14, Figure 14. | |
|
| |
Decorative and Protective | The grille must be securely attached. | |
Grille (optional) | Check that the side reflector extensions are installed correctly and secured in | |
| ||
| place if necessary. (Decorative grille only.) | |
| See Page 31, Section 7.5 and Page 33, Section 7.6. | |
| Make sure shield is installed correctly and secured in place if necessary. | |
| (Decorative grille only.) See Page 32, Section 7.5.2. | |
|
| |
Lower Clearance Shield | The lower shield must be securely attached. Inspect shield support straps | |
(optional) | and lower clearance shield anchor points. See Page 31, Section 7.4. | |
| Make sure shield is installed correctly and secured in place if necessary. | |
| See Page 31, Section 7.4. | |
|
| |
Wall Tag | If wall tag is present, make sure it is legible and accurate. Please contact | |
| ||
| if you need a wall tag. See Page 4, Section 2.1. | |
|
| |
Safety Labels | Product safety signs or labels should be replaced by the product user when | |
| they are no longer legible. Please contact | |
| ERTS GORDON® independent distributor to obtain replacement signs or | |
| labels. See Page 2, Figure 1 through Page 3, Figure 2. | |
|
|
47