Operating your radio - FM Auto Tune
1.Fully extend the telescopic aerial. The aerial should be fully extended and positioned vertically for optimum reception.
2.Press the On / Off button to switch on your radio.
3.Press and release the Band button until the FM band is selected.
4.Press and release the Tuning Up button to cause your radio to search from low frequency to high frequency and to stop automatically when it finds a station of sufficient strength.
Note: If your radio does not auto scan, press and release the Select
button until the display shows 'Auto Scan: ON'.
5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name.
6.To find other stations press and release the Tuning Up button as before.
7.Press and release the Tuning Down button to cause your radio to search from high frequency to low frequency and to stop automatically when it finds a station of sufficient strength. When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.
8.Adjust the Volume and Tone controls to the required setting.
9.To switch off your radio press the On / Off button.
3
7 4,6
88
Note:
If you find that FM reception is poor, try repositioning the Telescopic aerial. Fully extend and position vertically for optimum reception. If you find that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 16 for further details.
13
