Rockford Fosgate 250.2 manual Specifications, Watts, 1420

250.1 SPECIFICATIONS

Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V

Mono into a 4Ω load	420	Watts
Mono into a 2Ω load	710	Watts
Bridged (using 2 Punch 250m) into a 4Ω load	1420	Watts*
Continuous Power Rating (Competition Standard)	– Measured at 13.8 Volts
RMS continuous power mono, into a 4Ω load from 20-20,000Hz
with less than 0.10% THD	250 Watts
RMS continuous power mono, into a 2Ω load from 20-20,000Hz
with less than 0.15% THD	500	Watts

RMS continuous power bridged, (using 2 Punch 250.1

Power amplifiers in the same system) into a 4Ω load

from 20-20,000Hz with less than 0.15% THD	1000 Watts
Signal-to-Noise Ratio:	>100dB (A-weighted)
Frequency Response:	20Hz-20,000Hz ±0.5dB
Bandwidth:	10Hz–250kHz ±3dB
Damping Factor @ 4Ω (at output connector):	>200
Slew Rate:	50V ms
IM Distortion (IHF):	<0.05%
Input Impedance:	20k Ohms
Source Unit Compatibility (+15dB Gain Overlap):	28V max. input
Input Sensitivity (+0dB Gain Overlap):	Variable from 300mV to 5V
Pass-Thru Output:	Unity Gain
B+ Fuse Size: (External to amplifier)	60 Amp or two 30 Amp
Fuse Type:	AGU / Maxi Fuse
Crossover Slope:	12dB or 24dB/octave Butterworth
Factory Crossover Frequency:	80Hz (0.047mf)
Factory Default Crossover Setting:	Full Range
Dimensions:	9-5/8"W x 14-9/32"L x 2-5/8"H
	(24.4cm) x (36.27cm) x (6.6cm)

*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.

Specifications subject to change without notice.

– 47 –