183
Adding Effects

Adding Effects

You can use the REALTIME CONTROL knobs to edit up to four
of the most important parameters, which have been pre-selected
for each type of Reverb. When you enter the MFX 1–3 screen, the
indicator at the right of the Realtime Control knobs will go out,
and the Realtime Control knobs can be used to edit the MFX
parameters. If you once again press the button located at the
right of the Realtime Control knobs so the indicator is lit, the
knobs will control their original functions. When you exit the
MFX 1–3 screen, the indicator will automatically return to its
previous lit state.

Mastering Effect

This is a stereo compressor (limiter) that is applied to the final
output of the Fantom-S. It has independent high, mid, and low
ranges. Independently for the high-frequency, mid-frequency, and
low-frequency regions, this compresses any sounds that exceed the
specified level, making the volume more consistent. When mixing
down to MD, or DAT, or when you procedure your own original
audio CD, this lets you master at an optimized level.

* Mastering effect settings apply to the entire Fantom-S. These settings
are not for individual patches or performances.
* The mastering effect is applied to the sound that is output from the
OUTPUT A (MIX) jacks. It will not be applied to the sound that is
output from the OUTPUT B jacks.

fig.14-11_50

For details on the setting, refer to

“Making Effect Settings”

(p. 175)

ATTACK

Time from when the volume goes up the threshold level until the
compressor effect applies

Value:

0-100 ms

RELEASE

Time from when the volume falls below the threshold level until the
compressor effect no longer applies

Value:

50-5000 ms

THRESHOLD

Volume level at which compression begins

Value:

-36-0 dB

RATIO

Compression ratio

Value:

1.00:1-INF:1 (INF: infinity)

LEVEL

Output volume

Value:

0-24 dB

Split Frequency High

Frequency at which the high-frequency (HI) and mid-frequency
(MID) bands are split

Value:

2000-8000 Hz

Split Frequency Low

Frequency at which the low-frequency (LO) and mid-frequency
(MID) bands are split

Value:

200-800 Hz

Function Button Explanation

[1]–[5] Recall preset settings for each type.
[6 (User)] Recall saved user settings.
[7 (System Write)] Save the current settings as user settings.
Only one set of user settings can be saved.
[8 (Effect Sw] You can press this to open the Effect Sw win-
dow and turn each effect on/off. Turn [6
(Mastering Sw)] on/off to hear the result of
the mastering effect.

About THRESHOLD and RATIO

As shown in the diagram below, these parameters determine
how the volume is to be compressed.
.fig.Comp.e
1:1
2:1
4:1
INF:1
THRESHOLD
Input Level
Output Level
RATIO
Reference_e.book 183 ページ ２００３年７月１４日　月曜日　午後３時２５分