53
Creating a Patch

Creating a Patch

Adjusting the Volume (TVA/TVA Env)

fig.03-18_50

For details on the setting, refer to

“How to Make the Patch
Settings”

(p. 39).

TVA

Tone Level

★

Sets the volume of the tone. This setting is useful primarily for
adjusting the volume balance between tones.

Value:

0–127

Level V-Curve (TVA Level Velocity Curve)

You can select from seven curves that determine how keyboard
playing strength will affect the volume. If you do not want the
volume of the tone to be affected by the force with which you play
the key, set this to “FIXED.”

Value:

FIXED, 1–7

fig.Curve-7

Level V-Sens (TVA Level Velocity Sensitivity)

Set this when you want the volume of the tone to change depending
on the force with which you press the keys. Set this to a positive (+)
value to have the changes in tone volume increase the more
forcefully the keys are played; to make the tone play more softly as
you play harder, set this to a negative (-) value.

Value:

-63– +63

If you wish to make adjustments to the entire patch while
maintaining the relative values of TVA Level Velocity Sensitivity
among tones, adjust the Velocity Sens Offset parameter (p. 44).
However, this setting is shared by the Cutoff V-Sens parameter
(p. 51).

Bias

Bias causes the volume to be affected by the keyboard position. This
is useful for changing volume through keyboard position (pitch)
when playing acoustic instruments.

fig.Bias.e

Bias Level

Adjusts the angle of the volume change that will occur in the
selected Bias Direction. Larger settings will produce greater change.
Negative (-) values will invert the change direction.
Value:
-100, -90, -80, -70, -60, -50, -40, -30, -20, -10, 0, +10, +20, +30,
+40, +50, +60, +70, +80, +90, +100

Bias Position

Specifies the key relative to which the volume will be modified.

Value:

C-1–G9

Bias Direction

Selects the direction in which change will occur starting from the
Bias Position.

Value
LOWER

:The volume will be modified for the keyboard area below
the Bias Point.

UPPER:

The volume will be modified for the keyboard area above
the Bias Point.

LO&UP:

The volume will be modified symmetrically toward the left
and right of the Bias Point.

ALL:

The volume changes linearly with the bias point at the
center.

Tone Pan

★

Sets the pan of the tone. “L64” is far left, “0” is center, and “63R” is
far right.

Value:

L64–0–63R

Pan Key Follow

Use this parameter if you want key position to affect panning.
Positive (+) settings will cause notes higher than C4 key (center C) to
be panned increasingly further toward the right, and negative (-)
settings will cause notes higher than C4 key (center C) to be panned
toward the left. Larger settings will produce greater change.

Value:

-100– +100
1
1234567
C-1 G9
+
0
–
C-1 G9
+
0
–
C-1 G9
+
0
–
C-1 G9
+
0
–
+
0
–
+
0
–
LOWER
LO&UP
UPPER
ALL
Bias Position
Level
Level
Level
Level
Key
Key
Key
Key
Bias Position
Bias Position
Bias Position
2
3
Reference_e.book 53 ページ ２００３年７月１４日　月曜日　午後３時２５分