2 Basic Operation
2-7 Ending Printing Operations
Remove the Material
1 | If you wish to cut off the piece of the rolled material |
containing the printed area, press the [SHEET CUT] | |
| key. Hold down for about 2 second. |
| The piece is cut off at the present location of the |
| |
| * This operation isn't |
| necessary when sending a |
| |
| from the computer to |
| separate the material |
| automatically. |
3 | unit.Move the sheet loading lever toward the back of the |
| The pinch rollers rise to release the material. |
Sheet loading lever
2 | Press the [SETUP] key. Hold down for about 1 |
second. |
The SETUP LED goes out
4 | Open the front cover. |
To remove the material, follow the steps for loading it |
in reverse.
Separating the Printed Portion
Either of two methods can be used to separate a portion that's already been printed from the roll. One method is to press the [SHEET CUT] key. The other method is to perform separation automatically by sending a
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 2 seconds or longer severs the material at the present position of the
The material is cut off here. |
| Knife guide | |
| |||
|
|
|
|
|
|
|
|
Printed portion
31