2 Basic Operation

Making Corrections for Printing

Feed Correction

This corrects for errors in the amount of feed of the grit rollers due the type of material. Be sure to make this setting when you have replaced the material with a different type.

Correcting the amount of feed improves the dot-positioning accuracy in the feed direction, which can help enhance image quality.

When performing test printing for feed correction, load the material correctly (see "2-4 Loading the Material"). If the material is not loaded correctly, an accurate correction value may not be output.

1

Press the [MENU] key and [ ] key to make the

following screen appear on the display.

MENU

CALIBRATION

3

Press the [ENTER] key to start

printing a test pattern.

2

Test pattern

Press the [ ] key to make the following screen appear on the display.

CALIBRATION

TEST PRINT

+0.30%

4

Check the test pattern and choose a

+0.25%

 

 

 

value with no displacement.

+0.20%

Value with no

 

 

displacement

+0.15%

+0.10%

* Printing a Pattern in Steps of 0.10%

+0.05%

0.00%

5

6

Press the [ ] key to make the following screen appear on the display.

CALIBRATION

ADJUST

Press the [ ] key to make the following screen appear on the display.

ADJUST -0.10% -0.10%

-0.05%

-0.10% Current setting

-0.15%

7

Use the [ ] and [ ] keys to set the value you

checked in step 4, then press the [ENTER] key.

ADJUST -0.10% +0.20%

-2.0% to +2.0% (In steps of 0.05%)

*Test printing prints the pattern in steps of 0.10%. You can make the setting for steps of 0.05% on the display, but you should set the correction value to a adjust chosen from the test pattern.

29