2 Basic Operation

3

4

Place the roll material on the shaft and fit the hole at the left-hand side all the way onto the left-hand media flange.

Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw to secure in place.

Roll material

Rear

5

Pass the end of the material through the unit from back

to front.

Line up the end of the material with the lines of reflective tape.

If the front edge of the material has been cut at an angle, pull out the material so that all of the material covers the reflective tape.

6

With the material pulled out from the roll stretched

taut with no slack, move the sheet loading lever

toward LOAD.

The pinch rollers lower to hold the material in place.

Front

Reflective tape

Front edge of the material

Rear

Entire material stretched taut

Sheet loading lever

7

Close the front cover, and press the [SETUP] key.

This detects the width of the material and displays the

 

printable width.

 

 

 

The SETUP LED lights up

 

 

 

 

Top menu

 

 

 

 

W 1234 mm

 

 

 

 

FINE

BI-DIR

 

20