4 User's Reference

[INVALID SHEET] appears and the material cannot be detected even when the [SETUP] key is pressed

If the material loaded on the unit is transparent, then at the [SHEET TYPE] menu, select [CLEAR].

1

Press the [MENU] key and [ ] key to make the

following screen appear on the display.

MENU

SHEET TYPE

3

Use the [

] key to select [CLEAR], then press the

[ENTER] key.

 

SHEET TYPE

 

OPAQUE

CLEAR

-When the setting for [SHEET TYPE] is changed after setup for the material has been performed, the setup for the material is automatically canceled. If this happens, set up the material again.

-When using opaque material, return the [SHEET TYPE] setting to [OPAQUE].

2

 

 

Press the [

] key to make the following screen

 

 

appear on the display.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SHEET TYPE

 

4

 

 

 

 

 

OPAQUE OPAQUE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Specify a printing area for the left-right direction (the

 

 

direction of carriage movement) that matches the

 

 

 

 

 

 

 

width of the material. For more information, see " 2-6

 

 

 

 

 

 

 

Performing Printing -- Performing Printing at the

 

 

 

 

 

 

 

Desired Location -- Setting the printing area in the

 

 

 

 

 

 

 

left-right direction (the direction of carriage move-

 

 

 

 

 

 

 

ment)."

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When [SHEET TYPE] has been set to

 

 

 

 

 

 

 

 

[CLEAR], no detection of the material is

 

 

 

 

 

 

 

 

performed when material is loaded. This

 

 

 

 

 

 

 

 

means it is necessary to specify a printing

 

 

 

 

 

 

 

 

area that matches the actual width of the

 

 

 

 

 

 

 

 

material.

 

 

 

 

 

 

 

 

When only set to [CLEAR], the printable

 

 

 

 

 

 

 

 

width is set to the maximum (FJ-50: 1322

 

 

 

 

 

 

 

 

mm (52"), FJ-40: 1066 mm (42")).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If the "INK EMPTY" message appears during setup

A cartridge has run out of ink, and printing cannot be started.

If printing data is being sent, this message is displayed and the buzzer sounds. At the same time, operation is paused and the PAUSE LED flashes. Replace the empty cartridge with a new one and press the [PAUSE] key to start printing.

56