82

Effects List

The GW-8’s Chorus effect unit can also be used as a stereo delay unit.

These settings allow you to select chorus or delay, and the characteristics of the selected effect type.

If you specify the delay time as a note value, slowing down the

tempo will not change the delay time beyond a certain length.

This is because there is an upper limit for the delay time; if the

delay time is specified as a note value and you slow down the

tempo until this upper limit is reached, the delay time cannot

change any further. This upper limit is the maximum value that

can be specified when setting the delay time as a numerical

value.

note:

fig.MFX-note2.e

Chorus Parameters

Parameter Value Description
Chorus Type

0 (OFF),
1 (CHORUS),
2 (DELAY),
3 (GM2 CHORUS)
Selects either Chorus or Delay.
0 (OFF): Neither Chorus or Delay is
used.
1 (CHORUS): Chorus is used.
2 (DELAY): Delay is used.
3 (GM2 CHORUS): GM2 Chorus is
used.

01: CHORUS

Rate

0.05–10.00 Hz,
note Frequency of modulation

Depth

0–127 Depth of modulation

Pre Delay

0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.

Feedback

0–127
Adjusts the amount of the chorus sound
that is fed back into the effect.

Filter Type

OFF, LPF, HPF
Type of filter
OFF: no filter is used
LPF: cuts the frequency range above
the Cutoff Freq
HPF: cuts the frequency range be-
low the Cutoff Freq

Cutoff Freq

200–8000 Hz Basic frequency of the filter

Phase

0–180˚ Spatial spread of the sound

02: DELAY

Delay Left

0–1000 ms, note Adjusts the delay time from the direct
sound until the delay sound is heard.

Delay Right
Delay Center
Center Feed-
back

-98–+98%
Adjusts the proportion of the delay
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.

HF Damp

200–8000 Hz,
BYPASS
Adjusts the frequency above which
sound fed back to the effect will be cut.
If you do not want to cut the high fre-
quencies, set this parameter to BY-
PASS.

Left Level

0–127 Volume of each delay sound

Right Level
Center Level

03: GM2 CHORUS

Pre-LPF

0–7
Cuts the high frequency range of the
sound coming into the chorus.
Higher values will cut more of the
high frequencies.

Level

0–127 Volume of the chorus sound

Feedback

0–127
Adjusts the amount of the chorus sound
that is fed back into the effect.

Delay

0–127 Adjusts the delay time from the direct
sound until the chorus sound is heard.

Rate

0–127 Frequency of modulation

Depth

0–127 Depth of modulation

Send Level To
Reverb

0–127
Adjusts the amount of chorus sound
that will be sent to the reverb.

Double note

Dotted whole note

Dotted half note

Dotted thirty-second note

Whole note Double-note triplet

Sixteenth-note triplet

Thirty-second note

Sixty-fourth-note triplet

Sixty-fourth note

Thirty-second-note triplet

Dotted eighth noteQuarter-note tripletEighth note

Half-note tripletQuarter note Dotted quarter note

Whole-note triplet

Half note

Sixteenth note Eighth-note triplet

Dotted sixteenth note

GW-8_e.book 82 ページ 2008年4月1日 火曜日 午前11時44分