
7. Loading Material
Do not attempt to change a roll material while the power remains switched on.
The
Roll material must be placed at a predetermined shaft position.
Failure to do so may allow the material to fall, leading to injury.
*For detailed informa- tion on loading material, please refer to the CJ/FJ user's
manual.
NOTICE | When in the manual mode, make sure there is some slack in the material before attempting to perform |
|
|
Mounting the Flange and Paper Tube
1 | Pull out the stopper. |
Align the flange with the
2 groove on the shaft, and press in all the way.
Follow steps 1 to 3 to mount the
4 flange for the frame as well.
6 Tighten the mounting screws securely.
3 | Insert the stopper. | ||
|
|
|
|
5 Mount the paper tube.
When using the core from
When mounting the paper tube on the flanges, make sure that the paper tube fits snugly. Attempting to take up material when the paper tube is not stable may cause problems such as the pa- per tube coming loose. The outer diameter of the flange portion where the paper tube is fitted is shown below.
Side view of flange
76.2 mm |
| 50.8 mm |
| ||
(3 in.) |
| (2 in.) |
|
|
|
Make sure the margin described below is present between each flange and the edge of the material. Attempting to take up material when no margin is present may cause the material to touch the flange and result in faulty
| Paper tube |
| Sheet |
Flange | Flange |
20 mm (13/16 in.) or more
11