Roland user manual Specifications, TU-60 TU-70 TU-400 TU-500

Take-up of non-stiff material (such as synthetic paper, matte) is not straight

The problem is caused by wrinkling and slack in the material due to static electricity.

If you're using the TU-400/500, insert the included dancer roller at the area shown in the figure to maintain tension in the material.

If you're using the TU-60/70, insert the leftover core from used-up roll material or one of the shafts included with the stand for the FJ (the PNS- 50/40).

Dancer roller (if using the TU-400/500) or roll-material core or shaft (if using the TU-60/70)

12.	Specifications
			TU-60		TU-70			TU-400			TU-500
Acceptable media widths			210—1050 mm		210—1300 mm			210—1125 mm			210—1371 mm
			(8-1/4—41-5/16 in.)		(8-1/4—51-1/8 in.)		(8-1/4—44-1/4 in.)			(8	-1/4—53-15/16 in.)
Material weight for which take-up is possible			17 kg (37.4 lb.) or less		20 kg (44 lb.) or less			17 kg (37.4 lb.) or less			20 kg (44 lb.) or less
Maximum material diameter after take-up					180 mm (7-1/16 in.)
Speed during material take-up					AUTO: 39 rpm	MANUAL: 39 rpm
Control switches					POWER, AUTO, MANUAL
Power consumption				Exclusive AC adapter DC+9.7 V 0.7 A					+31 V 0.7 A
Acoustic noise level			Take-up mode: 70 dB (A) or less					(According to ISO7779)
Total weight of contents		TUC-60/70			6.5 kg (14.3 lb.)
		TU-**	2 kg (4.4 lb.)		2.5 kg (5.5 lb.)			2.5 kg (5.5 lb.)			3.0 kg (6.6 lb.)
Operating	temperature				5—40 °C (41—104 °F)
Operating humidity					20—80% (non-condensing)
Included items		TUC-60/70	Frame x 1, Control box (including the electrical adapter) x 1,						Flange x 2,	Sensor x 1, Arm x 1,
			Mirror x 1, Mirror stopper x 1 set, Hex wrench (large) / (Small)						1 each,
			Cap screw (large) x 8, Cap screw (middle) x 2,			Cap screw (middle) x 2, Cap screw (small) x 6,
			Cable retainer (large) x 1,		Cable retainer (small) x 5,			User’s Manual x 1
		TU-**	Rail slider x 1, Paper tube x 1, Gauge x 1				Rail slider x 1, Paper tube x 1, Gauge x 1, Dancer Roller x 1
Remarks			The automatic take-up function on the TU cannot be used when performing any of the following operations on
			the CJ/FJ.

•Automatic separation of the material, and separation of the material by pressing the [SHEET CUT] key.

•Return of the material using the or key.

•There is no material at the TU's sensor detection area.

[For the CJ only]

•Setting the prefeed function to [ENABLE].

•Enable the cutting function for the application software you’re using.

•From the display menu, select something other than [ROLL] for the material

•When loading material, automatic detection of the base point or align point was performed.

17